Go Ahead and Play Project Photos

A slide-show of photos of many of the piano’s from the Women’s Fund of Central Indiana’s “Go Ahead and Play” Project. Now that the pianos are out and about through the downtown area, check out some photos of the various artist’s work. And visit the pianos while you’re out at GenCon or IndyFringe this weekend. There’s a handy map here to find them.

Other than our own yarn-bombed piano, there are definitely several that I was enamored of, especially the Hidden Objects seek and find – the silver one – created by Go students in first through fifth grades. There’s just so much interesting stuff to find on that piano that I could have looked at it all day. I especially loved that there’s a monster truck rally taking place on top of the piano.

Go Ahead and Play Project

Continue ReadingGo Ahead and Play Project Photos

Voyageur Cap

  • Post author:
  • Post category:Knitting

Source: Wayback Machine Archive, Charitable Crafters Site

Author: Tina Shaddox

Tina’s Note: I did not write this pattern, it was an old pattern that I acquired and was written not only poorly but also incorrectly. It is a fun and cute hat and worth making. I hope I have improved upon it. — Tina Shaddox

Hawthorn’s Note: I’m saving this pattern to my site because the only place it currently exists is the Wayback Machine, and it’s somewhat hard to read on that page. I’ve also added some notes for other Ravelry knitters who increased the cast on did some paired SSK and K2tog decreases to improve the lines.

See my first attempt at this hat on Ravelry.com

Materials Needed:

  1. 4 oz of a worsted weight wool-bright red if you want an authentic cap
  2. 16-inch circular and a set of double points in your needle size.

Getting Gauge:

  • 4 stitches to the inch to make a 19.5″ hat (good for a 22 inch head – adult male)
  • 4.5 stitches to the inch to make a little over a 17″ hat (good for a 20 inch head – adult female)
  • 5 stitches to the inch to make a smaller hat of 15.6″ (good for an 19″ head-older child or teen)

Start your gauge swatch with a size 8 needle. If you don’t know the head size of the recipient, aim for 4.5 stitches to the inch. The average head size is between 20-21″.

Cast on 78 (84, 92) stitches on smaller needle. Join, being careful not to twist. Place a marker at the beginning of your round.

Knit 1 Purl 1 (or k2, p2) for 3 inches.

Switch to larger needle, begin stockinette stitch, knit for 4 inches (excluding ribbing).

For 92 stitches:

1st decrease round: Knit 20, SSK, Knit 3, K2tog, K39, SSK, Knit 3, K2tog, K19

For 78 stitches:

1st decrease round: Knit 16, SSK, Knit 3, K2tog, Knit 32, SSK, Knit 3, K2tog, Knit 16.

Knit 3 rounds

2nd decrease round: K 15, SSK, Knit 3, K2tog, Knit 30, SSK, Knit 3, K2tog, K 15

Knit 3 rounds

3rd decrease round: K 14, SSK, Knit 3, K2tog, K 28, SSK, Knit 3, K2tog, K 14

Knit 3 rounds

4th decrease round: K 13, SSK, Knit 3, K2tog, K 26, SSK, Knit 3, K2tog, K 13

Knit 3 rounds

5th decrease round: K 12, SSK, Knit 3, K2tog, K 24, SSK, Knit 3, K2tog, K 12

Knit 3 rounds

6th decrease round: K 11, SSK, Knit 3, K2tog, K 22, SSK, Knit 3, K2tog, K 11

Knit 3 rounds

7th decrease round: K 10, SSK, Knit 3, K2tog, K 20, SSK, Knit 3, K2tog, K 10

Knit 3 rounds

8th decrease round: K 9, SSK, Knit 3, K2tog, K 18, SSK, Knit 3, K2tog, K 9

Knit 3 rounds

9th decrease round: K 8, SSK, Knit 3, K2tog, K 16, SSK, Knit 3, K2tog, K 8

*NOTE Knit 2 rounds

10th decrease round: K 7, SSK, Knit 3, K2tog, K 14, SSK, Knit 3, K2tog, K 7

Knit 2 rounds

11th decrease round: K 6, SSK, Knit 3, K2tog, K 12, SSK, Knit 3, K2tog, K 6

Knit 2 rounds

12th decrease round: K 5, SSK, Knit 3, K2tog, K 10, SSK, Knit 3, K2tog, K 5

Knit 2 rounds

13th decrease round: K 4, SSK, Knit 3, K2tog, K 8, SSK, Knit 3, K2tog, K 4

Knit 2 rounds

14th decrease round: Knit 3, SSK, Knit 3, K2tog, K 6, SSK, Knit 3, K2tog, Knit 3

Knit 2 rounds

15th decrease round: K 2, SSK, Knit 3, K2tog, K 4, SSK, Knit 3, K2tog, K 2

Cut yarn leaving a 10 inch tail. Thread through remaining stitches and knot off, weaving in end on inside of hat.

Optional Tassel: Wind yarn 15 times around 4 fingers to make a loop. Remove loop from your fingers and tie together with a 10 inch long piece of yarn. Pull loop down so that it is suspended from your 10 inch tie. Take one end of the tie and wrap it several times around the loop, close to the area that is tied. You are going to make the top of the tassel look like a ball, or the head of a yarn doll. Tie off the wrapped end and let the remaining length hand down. Cut the loops that are hanging down so that the ends are even. Trim off any unwanted length. Use the remaining tie to thread through the end of your cap and fasten it off securely on the inside.

Historical Note: These caps were worn by the Voyageurs that made a name for themselves in the woods of Canada and in the Minnesota region for their hardiness and strength as they worked the fur trade. These are also similar to the style worn by the revolutionaries in France as heads rolled in the later 1700’s. It was not uncommon to have such words as “Liberty” or “Fraternity” stitched into the caps near the brim and they also go by the name “Liberty Caps”.

Continue ReadingVoyageur Cap

Dear Men in Congress: If we knit you a uterus, will you stay out of ours?

If they have their own, they can leave ours alone!

via Government Free VJJ | Dear Men in Congress: If we knit you a uterus, will you stay out of ours?.

  • Knit or crochet a vagina or uterus
  • Print a message to enclose
  • Mail it to your male Senator or Congressional Representative
  • We’re in the process of arranging hand delivery to congressional offices in Washington, until then, go ahead and mail yours in!
  • Record your items in this spreadsheet so we can track which representatives still need to receive a “gift”!
  • Don’t forget to thank your representative if he respects women and supports our rights.
Continue ReadingDear Men in Congress: If we knit you a uterus, will you stay out of ours?

Current Knitting Project: Doctor Who Scarf

Current Knitting Project: Doctor Who Scarf

I’m really in love with the way this scarf is looking. It took me a bit of trial and error to get the colors right; they don’t match the original perfectly (the purple should be more red, the green more brown-ish and the brown should be more orange), but they do balance well together the way the colors in the original did, and honestly, I prefer my variations of color to the ones that perfectly match. I’m surprised how quickly I’ve blazed through this. It is a long scarf however; even though it’s going quickly it’s not going to be finished soon.

Continue ReadingCurrent Knitting Project: Doctor Who Scarf

Super Hero Cape

Super Hero Cape

This is one of my current knitting projects – super hero capes for kids. I’m making at least three and possibly four of them; two red, (for Superman and Supergirl) one blue (Batgirl) and one white with gold trim (oh Mighty Isis), for some small folks I know. I started Saturday and made significant progress on one of them.

Continue ReadingSuper Hero Cape

Striped garter-stitch length-wise scarf

Striped garter-stitch length-wise scarf

Finished up this striped garter-stitch scarf knit length-wise. This is going to be one of my favorites to wear this winter; it’s made of Jo Sharp Tweed, which makes it really warm but also soft with lots of texture. It matches my favorite big brown wool coat, too. Because it’s knit the long way, it seemed to knit up really quickly; I know it wasn’t actually quicker when I look at when I started it, but the super long rows seemed that way.

Continue ReadingStriped garter-stitch length-wise scarf